AlgimycinPWF

When treating drinking water, what is the maximum allowable limit for applied metallic copper?

• 1 ppm ✓
• 5% copper
• 12.5 ppm
• 12.9 ppm

Answer: For drinking water, the label states applied metallic copper must not exceed 1 ppm.

🔗 Source

Which of the following target pests is AlgimycinPWF designed to control?

• Algae and cyanobacteria ✓
• Koi and hybrid goldfish
• Small volume garden pond organisms
• Dissolved organic carbon

Answer: The product is described as an algaecide and cyanobacteriocide used to control a broad range of algae and cyanobacteria.

🔗 Source

To prevent oxygen depletion in the water column, what is the restriction regarding the area treated?

• Do not treat more than 1/2 of the water body ✓
• Do not treat any water with a pH less than 6.5
• Do not treat water with dissolved organic carbon
• Do not treat water during temperature inversions

Answer: The label states: 'Do not treat more than 1/2 of the water body to avoid oxygen depletion.'

🔗 Source

Which set of Personal Protective Equipment (PPE) is required when handling this product?

• Respirator, goggles, and chemical apron
• Long-sleeve shirt, long pants, shoes and socks, and waterproof gloves ✓
• Face shield, rubber boots, and heavy-duty apron
• N95 mask, safety glasses, and nitrile gloves

Answer: The required PPE listed is a long-sleeve shirt, long pants, shoes and socks, and waterproof gloves.

🔗 Source

According to the label, where is AlgimycinPWF NOT intended to be used?

• Irrigation conveyance systems
• Small volume, garden pond systems ✓
• Potable water reservoirs
• Canals and laterals

Answer: The label explicitly states the product is not intended for small volume, garden pond systems.

🔗 Source

In regions where ponds freeze in the winter, when should treatment be applied?

• Immediately after the freeze occurs
• When water temperature drops below 60°F
• 6 to 8 weeks before the expected freeze time ✓
• During a temperature inversion in mid-winter

Answer: In regions where ponds freeze in winter, the label says to treat 6 to 8 weeks before expected freeze time.

🔗 Source

How should a technician determine the correct dosage for a specific application?

• Apply a flat rate of 5% copper per acre
• Use Table 1 and Table 2 to find required PPM, then convert via Table 3 ✓
• Apply until the water temperature reaches 60°F
• Maintain a constant concentration of 15 mph

Answer: Dosage is determined using Table 1 (by genera) and Table 2 (by growth form/abundance) to find the required PPM, then converted via Table 3.

🔗 Source

Under which weather conditions should a technician avoid applying AlgimycinPWF?

• When water temperature is above 60°F
• When wind speeds are greater than 15 mph ✓
• When the water is in a canal or ditch
• When the water contains low dissolved organic carbon

Answer: The label instructs to avoid application during temperature inversions or when wind speeds are greater than 15 mph.

🔗 Source