CrossFire Aerosol

To produce a 16 fl. oz. finished mix to treat 125 sq. ft., how much product is needed?

• 1.6 fl. oz. ✓
• 3.2 fl. oz.
• 6.5 fl. oz.
• 13.0 fl. oz.

Answer: The label states 1.6 fl. oz. of product with 14.4 fl. oz. of water produces 16 fl. oz. finished mix for 125 sq. ft.

🔗 Source

According to the label, what is the specific target pest for CrossFire Aerosol?

• Bed Bugs ✓
• Cockroaches
• Ants
• Fleas

Answer: The label facts explicitly list Bed Bugs as the target pest.

🔗 Source

Which of the following is a specific use restriction for CrossFire Aerosol?

• Do not apply in, on or around electrical equipment due to shock hazard ✓
• Do not apply in areas with high humidity
• Do not apply near open flames
• Do not apply in residential kitchens

Answer: The restrictions section states not to apply around electrical equipment due to the possibility of shock hazard.

🔗 Source

What Personal Protective Equipment (PPE) must applicators and handlers wear?

• Long-sleeved shirt, long pants, and shoes and socks ✓
• Chemical resistant gloves and goggles
• N95 respirator and face shield
• Coveralls and rubber boots

Answer: The PPE section requires a long-sleeved shirt, long pants, and shoes and socks.

🔗 Source

When preparing a 1.0 gallon finished mix to treat 1,000 sq. ft., what is the required amount of CrossFire Aerosol and water?

• 13.0 fl. oz. product and 115.0 fl. oz. water ✓
• 6.5 fl. oz. product and 57.5 fl. oz. water
• 19.5 fl. oz. product and 172.5 fl. oz. water
• 16.0 fl. oz. product and 128.0 fl. oz. water

Answer: The label states that 13.0 fl. oz. of product with 115.0 fl. oz. of water produces 1.0 gal. finished mix for 1,000 sq. ft.

🔗 Source

What is the required application method for treating Bed Bugs with this product?

• Apply as a coarse wet spray or spot treatment ✓
• Apply as a fine mist only
• Apply as a dry powder dusting
• Apply as a heavy flood spray

Answer: The label notes specify to apply as a coarse wet spray or spot treatment.

🔗 Source

What is the finished strength of the Bed Bug dilution mixes listed in the label?

• 1.42% ✓
• 1.00%
• 2.50%
• 0.50%

Answer: All mixing instructions provided in the label specify a finished strength of 1.42%.

🔗 Source

Based on the provided label facts, how much finished mix is required to treat 1,500 sq. ft.?

• 1.5 gal. ✓
• 1.0 gal.
• 0.5 gal.
• 2.0 gal.

Answer: The label specifies that 1.5 gal. of finished mix is used to treat 1,500 sq. ft.

🔗 Source