Dimension Ultra 40WP Herbicide

To ensure optimum effectiveness, how much rainfall or irrigation is recommended to activate the product?

• At least 1/4 inch
• At least 1/2 inch or more ✓
• Exactly 1 inch
• At least 2 inches

Answer: The label states the product is most effective when activated by 1/2 inch or more of rainfall or irrigation.

🔗 Source

What is the required Personal Protective Equipment (PPE) instruction regarding treated areas?

• Wear a respirator at all times during application
• Keep unprotected persons out of treated area until sprays have dried ✓
• Wear chemical-resistant gloves during re-entry
• Apply only when wearing full-body Tyvek suits

Answer: The PPE section states to keep unprotected persons out of the treated area until sprays have dried.

🔗 Source

Which of the following best describes the target pests for Dimension Ultra 40WP?

• Crabgrass and other annual grasses and broadleaf weeds ✓
• Perennial grasses and woody shrubs
• Only crabgrass in late stages of growth
• Insects and fungal pathogens in turf

Answer: The label states the product targets crabgrass and other annual grasses and broadleaf weeds.

🔗 Source

What is a critical restriction regarding the application method of this product?

• Do not apply via any type of irrigation system (chemigation) ✓
• Do not apply during daylight hours
• Do not apply using a backpack sprayer
• Do not apply if wind speeds are above 5 mph

Answer: The restrictions section explicitly states: 'Chemigation: Do not apply this product through any type of irrigation system.'

🔗 Source

When using liquid fertilizer as a carrier, what must be done first?

• Add the fertilizer to the tank before the herbicide
• Determine compatibility by mixing small proportional quantities in advance ✓
• Dilute the fertilizer with 1/2 inch of water first
• Ensure the fertilizer is a dry powder only

Answer: The label instructs to first determine compatibility by mixing small proportional quantities in advance.

🔗 Source

Regarding the timing of application for optimal weed control, when should Dimension Ultra 40WP be applied?

• Preemergence (prior to germination of target weeds) ✓
• After weeds have reached full maturity
• Only during the dormant season
• After the first heavy frost

Answer: The label notes that for optimum control, applications should be made preemergence, prior to germination of target weeds.

🔗 Source

When mixing Dimension Ultra 40WP alone with water, how long should you wait after adding the unopened packets before turning on the agitation?

• Immediately after adding packets
• 30 to 45 minutes
• 5 to 10 minutes ✓
• At least 1 hour

Answer: The mixing instructions state to wait 5 to 10 minutes to allow the packets to thoroughly dissolve before turning on agitation.

🔗 Source

According to the label, where is Dimension Ultra 40WP intended for application?

• Indoor residential carpets
• Outdoor sites such as lawns, golf courses, and ornamentals ✓
• Indoor greenhouse environments only
• Only inside commercial sod farms

Answer: The label specifies outdoor applications including established lawns, golf course fairways, and ornamentals.

🔗 Source