Ferti lome Tree and Shrub Systemic Insect Drench

Which of the following pests is specifically listed as being suppressed by the foliar application method?

• Black Vine Weevil Larvae
• Thrips ✓
• Emerald Ash Borers
• White grub larvae

Answer: The label lists thrips (suppression) under the foliar application target pests.

🔗 Source

Which pest group is included in the target list for soil application but NOT listed for foliar application?

• Aphids
• Japanese beetles
• Black Vine Weevil Larvae ✓
• Whiteflies

Answer: Black Vine Weevil Larvae is listed under soil application targets but is absent from the foliar application target list.

🔗 Source

To treat approximately 1,000 sq. ft. via soil application, what is the required amount of product and dilution?

• 3.0 fl. oz. per 1 gallon of water
• 6.0 fl. oz. per 2 gallons of water
• 9.0 fl. oz. per 3 gallons of water ✓
• 12.0 fl. oz. per 4 gallons of water

Answer: The label specifies 9.0 fl. oz. per three (3) gallons of water for treating approximately 1,000 sq. ft.

🔗 Source

What is the recommended interval between repeat applications if high pest pressure is observed?

• 5-7 days
• 10-14 days ✓
• 21-28 days
• Once every 30 days

Answer: The label advises repeat applications with 10-14 day intervals between applications.

🔗 Source

According to the label, where should the product be applied for 'Established plantings'?

• Directly onto the leaf undersides
• As a broadcast treatment to the seedbed
• To the root zone of the established plants ✓
• To the stems and branches only

Answer: For established plantings, the label says to apply the drench to the root zone of the established plants.

🔗 Source

What must be done after applying the Ferti lome Tree & Shrub Drench to the soil?

• Wait 24 hours before watering
• Irrigate the treated area (0.5 inch) thoroughly ✓
• Apply a foliar spray immediately after
• Mulch the area to prevent evaporation

Answer: The label instructions state to 'Irrigate the treated area (0.5 inch) thoroughly after the application'.

🔗 Source

When using a Hose-End Sprayer for foliar applications, what instruction is provided regarding the jar?

• Fill the jar halfway with water
• Do not add water to jar ✓
• Mix 1 tsp per gallon in the jar
• Add water until the dial reaches 1.5

Answer: For the Hose-End Sprayer dial setting for foliar pests, the notes state 'Do not add water to jar.'

🔗 Source

When performing a foliar application, what is the recommended timing regarding plant flowers?

• During full bloom to ensure coverage
• Only when flowers are in the budding stage
• Prior to blooming or after all flower petals have fallen off ✓
• Immediately after the first bloom cycle ends

Answer: The label states to make the application prior to blooming or after all flower petals have fallen off.

🔗 Source