InVict Gold Roach Bait Gel

Which of the following is a prohibited application site for this product?

• Cracks and crevices
• Wall voids
• Bodies of water ✓
• General surfaces

Answer: The restrictions section states: 'Do not apply this product in or around bodies of water.'

🔗 Source

When performing a General Surface Application indoors for cockroaches and crickets, what is the required dilution rate?

• 1 fl. oz. of Tekko® Pro per gallon of water
• 2 ozs. per gal. of water ✓
• 1.5 fluid ounces of Tekko® Pro per gallon of water
• 1 fl. oz. of petroleum distillate per gallon of water

Answer: For indoor General Surface Application, the label states a rate of 2 ozs. per gal. of water.

🔗 Source

When performing an outdoor perimeter treatment, what is the recommended height for application on the foundation?

• 1 to 2 feet
• 2 to 3 feet ✓
• 3 to 4 feet
• 4 to 5 feet

Answer: The label instructs to 'Apply at a height of 2 to 3 feet on the foundation.'

🔗 Source

According to the label, what is a specific restriction regarding the application of this product?

• Do not apply during the daytime
• Do not apply when windy ✓
• Do not apply in residential areas
• Do not apply more than once a year

Answer: The timing/weather section explicitly states: 'Do not apply when windy.'

🔗 Source

What must be done after injecting an aerosol spray into wall voids and small structural void areas indoors?

• Wait 24 hours before re-entry
• Ventilate area thoroughly before re-entry ✓
• Apply a second coat of petroleum distillate
• Repeat treatment every 6 months

Answer: The label instructions for wall voids state to 'Ventilate area thoroughly before re-entry.'

🔗 Source

Which pests are targeted when performing an outdoor perimeter treatment with InVict Gold Roach Bait Gel?

• Cockroaches and crickets ✓
• Stored product pests
• Indian meal moths and rice moths
• Dermestid beetles only

Answer: The label specifies cockroaches and crickets as the target pests for outdoor perimeter treatments.

🔗 Source

To treat wall voids and other small structural void areas indoors, how much total solution is produced when mixing 1 fl. oz. of Tekko® Pro with 1 fl. oz. of water?

• 1 fl. oz.
• 2 fl. oz. ✓
• 1.5 fl. oz.
• 4 fl. oz.

Answer: The label states that mixing 1 fl. oz. of Tekko® Pro with 1 fl. oz. of water results in 2 fl. oz. of solution.

🔗 Source

When treating stored product pests, what is the correct dilution ratio?

• 1 fl. oz. of Tekko® Pro per gallon of water
• 2 ozs. per gallon of water
• 1.5 fluid ounces of Tekko® Pro per gallon of water ✓
• 2 fl. oz. of Tekko® Pro per gallon of water

Answer: For stored product pests, the label requires 1.5 fluid ounces of Tekko® Pro per gallon of water.

🔗 Source