PerCarb California

What is the re-entry interval (REI) for enclosed environments?

• 1 hour ✓
• 4 hours
• 12 hours
• 24 hours

Answer: The label lists the REI as 1 hour for enclosed environments.

🔗 Source

When mixing PerCarb California, which of the following must be avoided to prevent loss of effectiveness?

• Acidic pH solutions ✓
• Soap and water
• Alkaline solutions
• Large volumes of water

Answer: The label states: 'Do not mix with acidic pH solutions, as this may cause loss of effectiveness.'

🔗 Source

What is the required Personal Protective Equipment (PPE) for handling this product?

• Long-sleeved shirt, long pants, and shoes ✓
• Chemical resistant gloves and goggles
• Respirator and face shield
• Full body Tyvek suit

Answer: The PPE section specifies wearing long-sleeved shirt, long pants, and shoes.

🔗 Source

Which of the following diseases is PerCarb California specifically noted to control?

• Powdery mildew and bacterial infections ✓
• Aphids and spider mites
• Root rot and fungal wilt
• Locusts and grasshoppers

Answer: The label states it is used to control diseases such as powdery mildew, leaf spots, and various bacterial infections.

🔗 Source

To protect pollinators, under what condition should you avoid applying PerCarb California?

• Do not apply to blooming crops or weeds where bees are active ✓
• Do not apply during the night
• Do not apply when wind speeds are high
• Do not apply during the early morning

Answer: The product is highly toxic to bees and the label instructs not to apply to blooming crops or weeds where bees are active.

🔗 Source

According to the label, where should PerCarb California be applied?

• Outdoor field crops, tree crops, berries, small fruits, or vine crops ✓
• Indoor greenhouse environments only
• Directly into irrigation systems
• As a directed spray or drip

Answer: The label specifies outdoor use on field crops, tree crops, berries, small fruits, or vine crops.

🔗 Source

What is the correct application rate for PerCarb California per 25 gallons of water?

• 0.25-0.75 lbs. ✓
• 1.0-2.0 lbs.
• 5.0-10.0 lbs.
• 0.10-0.50 lbs.

Answer: The application rate listed is 0.25-0.75 lbs. per 25 gallons of water.

🔗 Source

What environmental timing restriction is mentioned regarding amphibians?

• Avoid application during amphibian breeding seasons ✓
• Only apply during amphibian hibernation
• Apply only after amphibian breeding seasons end
• Avoid application near water bodies containing amphibians

Answer: The label explicitly states to avoid application during amphibian breeding seasons.

🔗 Source