Termidor Foam

Which of the following pests is NOT listed as a target for Termidor Foam?

• Subterranean termites
• Carpenter ants
• Bed bugs ✓
• Drywood termites

Answer: The label lists termites (subterranean, arboreal, drywood, dampwood), carpenter ants, beetles, and borers, but does not mention bed bugs.

🔗 Source

If you are mixing 1.0 gallon of water to achieve a 0.09% finished strength, how much product is required?

• 0.4
• 0.8
• 1.2 ✓
• 1.6

Answer: For a 0.09% finished strength, the amount required per 1.0 gal water is 1.2.

🔗 Source

What is the application rate for vertical treated zones along the interior and exterior perimeter of foundation walls?

• 1.0 to 1.5 gallons per 10 square feet
• 2 gallons per 10 linear feet per foot of depth ✓
• 0.06% finished strength per foot
• 10 gallons per 25 linear feet

Answer: Vertical treated zones require 2 gallons per 10 linear feet per foot of depth.

🔗 Source

When treating concrete slabs on the ground or in basements (horizontal treated zones), what is the required application rate?

• 1.0 to 1.5 gallons per 10 square feet ✓
• 2 gallons per 10 linear feet per foot of depth
• 0.4 gallons per 10 square feet
• 1.5 gallons per 10 linear feet

Answer: For horizontal treated zones like concrete slabs, the rate is 1.0 to 1.5 gallons per 10 square feet.

🔗 Source

To achieve a finished strength of 0.125% using 25 gallons of water, how much product should be mixed?

• 19.0
• 39.0 ✓
• 78.0
• 156.0

Answer: The mixing instructions specify 39.0 amount per 25 gal water for a 0.125% finished strength.

🔗 Source

Which of these is a permitted site for vertical treated zones?

• Only exterior foundation walls
• Only interior foundation walls
• Perimeter of foundation walls and around pillars ✓
• Concrete slabs on ground

Answer: Vertical treated zones are applied along the interior and exterior perimeter of foundation walls and around pillars and other foundation elements.

🔗 Source

Which statement regarding application restrictions is TRUE based on the label?

• You may apply at 0.03% for vertical treatments.
• You may apply 1 gallon per 10 square feet for horizontal treatments.
• You must not apply at a lower finished dilution volume than 2 gallons per 10 linear feet per foot of depth for vertical zones. ✓
• You can apply at any concentration as long as it is above 0.01%.

Answer: The label explicitly states DO NOT apply at a LOWER finished dilution volume than 2 gallons per 10 linear feet per foot of depth for vertical treated zones.

🔗 Source

According to the restrictions, what is the minimum finished concentration allowed for horizontal and vertical treatments?

• 0.03%
• 0.06% ✓
• 0.09%
• 0.125%

Answer: The label states DO NOT apply at a LOWER dosage and/or concentration than 0.06%, 0.09%, or 0.125%.

🔗 Source