XT 2000

Before discharging effluent containing XT 2000 into sewer systems, what action must be taken?

• Notify the local sewage treatment plant authority ✓
• Dilute with water by a ratio of 10:1
• Test the pH level of the effluent
• Wait 24 hours for the product to settle

Answer: The label states not to discharge effluent to sewer systems without previously notifying the local sewage treatment plant authority.

🔗 Source

Which target pest is XT 2000 specifically indicated to control via the described application method?

• Structural Drywood Termite ✓
• Subterranean Termite
• Carpenter Ant
• Formosan Termite

Answer: The label facts explicitly list Structural Drywood Termite as the target pest.

🔗 Source

What is the maximum duration recommended for injecting the product into drilled holes?

• Up to one minute ✓
• Up to thirty seconds
• Up to five minutes
• Up to ten minutes

Answer: The label instructions specify to inject for up to one minute.

🔗 Source

When applying XT 2000 to infested wood, what is the recommended pattern and spacing for drilling holes?

• A 'W' pattern at 3"-5" intervals ✓
• A straight line at 1"-2" intervals
• A circular pattern at 5"-10" intervals
• A grid pattern at 4"-6" intervals

Answer: The label instructions state to use a 'W' pattern at 3"-5" intervals.

🔗 Source

Which of the following is a required component of the PPE for all pesticide handlers using XT 2000?

• Long-sleeved coveralls worn over a minimum of short-sleeved shirt and short pants ✓
• Full-body Tyvek suit with integrated hood
• Rubber apron and heavy-duty boots
• N95 respirator and chemical goggles

Answer: The PPE section requires long-sleeved coveralls worn over a minimum of a short-sleeved shirt and short pants.

🔗 Source

According to the label restrictions, what must a technician avoid when drilling into wood for treatment?

• Electrical wiring and plumbing ✓
• Painted surfaces
• Hardwood species
• Structural beams

Answer: The label explicitly states to avoid electrical wiring and plumbing when drilling.

🔗 Source

What is the restriction regarding reapplication of XT 2000 to the same area?

• Do not reapply again to same area within one year ✓
• Do not reapply to same area within 30 days
• Do not reapply to same area within 6 months
• Do not reapply to same area within 2 years

Answer: The label restrictions state: 'Do not reapply again to same area within one year.'

🔗 Source

When drilling holes into 'kick-outs' to intersect galleries, what size drill bit should be used?

• 7/64" ✓
• 1/8"
• 3/32"
• 1/4"

Answer: The label instructions specify to drill 7/64" holes into 'kick-outs'.

🔗 Source